▪️ Electric shutter consists of two main parts: blade and motor It is possible, but to install electric shutters, other accessories are also needed, which we mention below about electric shutter parts
✅ The main parts and components of the electric shutters
▪️ In general, electric shutter fittings are used when the parts and accessories of the electric shutter are fully available to the installer. Otherwise, not only will we face problems during installation, but also due to defects in the necessary parts, the electric shutter will remain unused; Therefore, before installing and setting up all types of electric shutters, make sure that you have prepared all the main parts and components so that you don't have any problems during installation. The main parts and accessories of the electric shutter are as follows:
- Electric shuttle blade
▪️ blade Electric shutters are designed and manufactured according to the needs of consumers in different types and sizes. The material of the blades is usually made of steel, stainless iron, aluminum, polycarbonate, etc., depending on the location and weather conditions, there are different options for selection and installation. For example, in humid and humid areas such as the north of the country and the coast of the Persian Gulf, aluminum electric shutter blades and polycarbonate shutters are often used; Because it is resistant to moisture and temperature and is less subject to erosion and decay. In other words, it can be said that the blade and its material are one of the main parts and accessories of electric shutters.
- Electric Shutters Engine
▪️ Engine The electric shutter is one of the most important parts of the electric shutter. So that the absence of this part or the failure to connect it correctly will cause the electric shutter to fail. In the Iranian market, two types of tubular motors and side motors are often used for electric shutters, and consumers are satisfied with these motors. It is worth noting that tubular motors are used for low-traffic places and light doors, and on the contrary, side motors are used for high-traffic places and heavy doors.
- shaft (tube)
▪️ This piece is used to install the electric shutter roll. So that when the engine is turned on, the shaft moves and the blades are wrapped around it.
- Emergency Power System (UPS)
▪️ This system is often used in side engines, and the shutter can be raised and lowered several times during a power cut.
- Plate plate
▪️ This piece is installed on the left and right sides of the electric shutter and its task is to keep the shaft on top of the shutter.
- Electric Shutters Remote
▪️ Using this piece, you can command the electric shutter motor from a few meters away and open and close it.
- Electric Shutters Rail
▪️ Rail is a profile that is installed on both the right and left sides of the opening of the electric shutter. After that, the blades are placed in it and they go up and down regularly and uniformly.
▪️ Among other parts and accessories of electric shutters, we can mention hair, caps, cans and jacks.